Miele K 32222 i Operating And Installation Instructions page 69

Installing the appliance.
 Push the appliance into the niche
until all fixing brackets are in line with
the front edge of the furniture side
wall.
–  With 16 mm thick walls:
The spacers should touch the front
edge at the top and bottom of the
side walls of the housing unit.
–  With 19 mm thick walls:
The front edges of the top and
bottom hinges should be flush with
the front edge of the housing side
wall.
Installing the appliance
 Check the position of the fixing
bracket at the top and bottom front
edge of the furniture side wall again.
This will create a gap all round of
42 mm to the front edges of the
housing unit side walls.
On furniture with door fittings (e.g.
stubs, seals etc.) the dimension of
these must be taken into account
when making sure there is a gap all
round of 42 mm.
 Pull the appliance forwards by the
appropriate dimension.
The hinges and covers will now
protrude by the dimension of the door
fitting.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture doors.
  Align the appliance on both sides
by altering the adjustable feet using
the spanner supplied.
If the all round gap of 42 mm is not
maintained between the appliance
housing and the front edge of the
housing unit side wall, the door may
not shut properly.
This can cause ice to build up,
condensate to accumulate and lead
to faults in the appliance. These can
all lead to increased energy
consumption.
69