Furniture Door Panel; Horizontal And Vertical Gaps - Miele K 32222 i Operating And Installation Instructions

Top ventilation gap
The ventilation gap at the top of the
appliance can be constructed in
different ways:
a directly above the appliance with a
ventilation grille (free airflow of at
least 200 cm²).
b in between the housing unit and the
ceiling
c through a suspended ceiling.

Furniture door panel

Horizontal and vertical gaps

Depending on the style of kitchen
furniture the thickness and edge radius
of the furniture door and the gap that
runs around the door, vertically and
horizontally, are specified.
It is essential to pay attention to the
following!
– Horizontal gap
The gap between the appliance
furniture door and the housing unit door
above or below it must be at least
3 mm.
– Vertical gap
If the gap between the appliance
furniture door and the adjoining
housing unit door or wall on the
hinged side is too small, the
appliance door could collide with the
adjoining housing unit door or wall
when opened.
It may be necessary to adjust the
size of this gap to suit the thickness
and edge radius of the appliance
furniture door.
This must be taken into consideration
when planning your kitchen and when
replacing an old appliance with a new
one to ensure the installation conditions
required are met.
Installation
53