Table of Contents
Advertisement
MAINTENANCE & INSPECTION
1.
Read, understand and follow the Product Manual and signs
on the product before using, maintaining or inspecting the
equipment.
2.
ANSI and OSHA require a regular inspection program
for all confined space entry/retrieval equipment and to
maintain documented results of these inspections. Follow
the inspection procedure contained in this manual and
use the inspection form to document the results.
For the most part, the Model #LG5 is intended to be a maintenance-free piece of equipment, however several steps can
be taken to keep the system in top-notch working order and also extend the working life of the product.
Before Each Use:
1. Visual Inspection: Perform a complete visual inspection. Refer to section 6.2 for guidelines and take any
maintenance steps that are necessary.
Annually:
1. Clean Product: Use a damp cloth and mild soap to clean the structure and labels of dirt and residue. Be sure
the labels are legible (replacements are available from Pelsue)
2. Complete Inspection: Perform a thorough inspection, paying attention to the bullet points provided within
section 6.2. Record results and keep documentation. A log has been provided in section 6.3 specifically for
the recording of the dates & results of annual system inspections.
Periodic Factory Service Inspection: It is recommended that the product be serviced by a factory authorized
service center or the manufacturer after a period of three years. Extreme working conditions may indicate
the necessity to increase the frequency. Factory servicing shall include but not be limited to an intensive
inspection and cleaning of all internal and external components. Failure to provide proper service may shorten
product life and could endanger performance or function.
When completing an inspection of the Model #LG5 Manhole Guard Retrieval System, the following specific items should
be checked;
1. Labels:
Check that all the labels are clean and legible (Refer to Section 3.1). Clean the labels if any are dirty using mild
soap and a damp cloth. Replace if any are illegible. Decals & labels provide valuable warning and caution infor-
mation applicable to product usage and limitations, and should be visible and present at all times.
2. Fasteners:
Check that all screws and other fasteners are present and secure. Note that not all fasteners are tightened to their
maximum allowable torque. This is done in order to allow for pivoting and folding motions in certain components.
Over-tightening of fasteners can interfere with the operation of the device and can damage the structure.
All fasteners on the Model #LG5 system are of a self-locking design. Bolt threads should extend all the way though
their locking nuts. If any fasteners have appeared to "back-out" or loosen the product should be removed from
service until the problem can be identified and corrected.
#500995-001 - Product Manual: #LG5 Series Manhole Guard Retrieval System - Revision 06 - Date: 01-09-2018
6.0 - Maintenance & Inspection
3.
keep instructional and safety signs clean and legible at
all times. Clean or replace as required.
4.
Remove the equipment from service if a problem is found
during the inspection. Return to an authorized repair depot
or the factory for service.
6.1 - Maintenance
6.2 - Inspection
Page 17
Advertisement
Table of Contents
