Table of Contents
Advertisement
Installation
Installing the Rider Platform
Refer to Figure 1.
1) Manually activate and lock wheel brakes.
2) Position wheel chocks against both sides of the tires. Make sure they are snug and in the center
of the tire.
3) Insert the mounting tubes of the Rider Platform (1) into the receiver tubes of the main tug
assembly. Line up the holes and lock into place using the bolts and washers (2) provided.
4) Install the Push/Pull control cables to the cable bracket.
5) Adjust the stop switch limit bolts until the cable's rod ends align with the tapped holes in the
cable brackets.
6) Bolt the cables rod ends into the bracket.
7) Adjust the stop switch limit bolts again to allow proper stroke of the gas springs.
Technical Manual & Parts Lists
5
Advertisement
Table of Contents
