weedingtech FoamStream M1200 User Manual page 26

M1200 – User manual – English (EU) – 01/03/2018 - ISSUE 2
Boiler not ready Red
Emergency stop
Red
activated
No flow at outlet Red
No flow at
Red
bypass
Press "Air bleed" Green
Machine ready,
Green
press "Start"
Boiler starting
Yellow
up
Water & Boiler
Yellow
pre-heating
The boiler fan is running
but the boiler is not running
as the 'ready' signal from
controller was not received.
Push on the 'reset' button
for 5 seconds and try again.
If the problem persists,
please call your
Weedingtech distributor.
The emergency stop button
is activated, release it and
press "reset".
The pump is running but no
flow is detected. Please
check the hydraulic panel
for leaks. If no leaks are
found, the flow switch
might be faulty.
The pump is running and
the water heating up but no
flow is detected in the
return to tank line. Please
check the hydraulic panel
for leaks. If no leaks are
found, the flow switch
might be faulty.
Press "Air bleed"
Press "Start"
Nothing
The boiler is warming up
the water to reach 95° and
will then open the lance
Air bleeding in
Green
progress
Pressure sensor
Red
fault
Outlet flow
Red
sensor fault
Inlet flow sensor
Red
fault
Boiler controller
Red
fault
Water pump
speed inverter Red
fault
Release trigger Yellow
valve. You have nothing to
do.
Wait until the bleeding is
complete
The pump is not running
but the pressure sensor
sends a signal. The
pressure sensor is faulty
and needs to be changed
The pump is not running
but the flow sensor sends a
signal. The flowswitch
needs to be changed
The pump is not running
but the flow sensor send a
signal. The flowswitch
needs to be changed
The boiler is not running
but ready signal from
controller is received.
Please contact a
Weedingtech distributor
Fault signal from speed
inverter. Please stop and
start the machine. If the
problem persists you will
need to contact a
Weedingtech distributor to
open the electrical box and
reset the inverter.
Release the trigger.
26