Advertisement
Foamstream M600 – User manual – English (EU) –16/05/2018 - ISSUE 3
Prestart checks
THE FOLLOWING CHECKS MUST BE COMPLETED BEFORE
EVERY START UP OF THE M600. ANY FAULTS MUST BE
RECTIFIED BEFORE THE M600 IS SWITCHED ON.
✓ The M600 is in good condition and securely attached to
the transport vehicle
✓ The M600 water tank is securely attached to the
transport vehicle
✓ The LPG cylinder is full, secured, and in good condition
✓ Water tank is full of clean water
✓ Water filter is clean and free from debris
✓ Air intakes are clear of debris
✓ The lance, hose reel and hose are securely connected
and free from damage
✓ Lance wear pads are not excessively worn
✓ The water return pipe and water level sensor are
connected
✓ Pipe/hose routes are clear of sharp edges and hot
surfaces
✓ There are no signs of leaks from any pipe or connection
✓ Fuel tank is full of clean diesel fuel
✓ Boiler fuel filter is clean and free from debris
✓ The Foamstream® concentrate has not been subject to
temperatures below 5°C and frozen or separated
✓ Foamstream® concentrate tank is full of clean
Foamstream® concentrate
✓ Foamstream® filter is clean and free from debris
✓ Vent screw on Foamstream® tank filler cap is open
✓ Generator engine oil level is correct
✓ Pump oil level is correct
✓ Generator and boiler exhaust are secure and clear of
debris and obstruction
✓ Fuel switch on generator is in the OFF position
✓ Generator is switched to normal mode
✓ Water feed valve is connected and in the ON (inline)
position
✓ Air has been bled from water system
✓ The LPG cylinder valve is connected and open
NOTE:
CLOSE LPG CYLINDER VALVE WHEN MACHINE IS NOT IN
OPERATION
NEVER RUN GENERATOR WITH LPG WHILE PETROL
REMAINS IN THE PETROL TANK.
4
Advertisement
