Foamstream M600 – Quick start-up guide – English (EU) – 16/05/2018 - ISSUE 3
Safety Information
To ensure safety while operating the M600, please carefully
read the following information.
Operator Attention
WARNING
•
Read and understand this user manual before operating
the M600.
•
The M600 should only be used by trained operators.
•
Proper PPE is to be worn at all times while operating the
M600.
•
Major repair work should only be carried out by
professionally trained service engineers.
Carbon Monoxide Hazards
WARNING
•
Boiler and generator exhaust contains poisonous carbon
monoxide gas.
•
Never run the M600 indoors, even if a door or window
is open. ONLY USE IN A WELL VENTILATED AREA.
•
Do not use the M600 in potentially expolosive
atmospheres.
Electric Shock Hazards
WARNING
•
Do not operate the M600's electrical components with
wet hands.
•
Do not expose the generator to rain, moisture, or snow.
•
Always ensure electric cables are in good condition.
Fire and Burn Hazards
WARNING
•
LPG and diesel are explosive and flammable. Always
ensure spark or fire source point away while refueling.
•
Do not refill diesel while machine is in use.
•
Clean up any overflowing fuel prior to turning on the
M600.
•
Never smoke while operating the M600.
•
Do not touch the working components in the M600 while
in use or immediately following use. Allow sufficient
time to cool before servicing.
•
Shut off generator by closing LPG supply to prevent
unburned gas from remaining in the system.
Generator Fuel Warning
WARNING
NEVER USE PETROL IN THE M600. ONLY USE LPT TO
FUEL THE GENERATOR.
If the generator is used outside the M600 as a backup
generator and petrol is used, follow the instructions below
prior to using the M600.
•
Remove all remaining petrol from generator and
clean all spills and allow to dry/evaporate
before putting the generator back inside the
M600.
•
Turn the fuel switch (item 7 in Figure 3) to the OFF
position.
•
Connect LPG cylinder and start as normal.