Page 1
AquaVac 6 Series ® Robotic Cleaner »»» Hayward Pool Products Hayward Pool Products Canada Hayward Pool Europe Hayward Pool Products (Australia) Pty Ltd. 620 Division Street 2880 Plymouth Drive 1070 Allée des Chênes Melbourne-Sydney-Brisbane-Perth Elizabeth, NJ 07207 Oakville, ON L6H 5R4 01150 St-Vulbas, France P.O Box 4384, Dandenong South VIC.
IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be observed including the following. Failure to adhere to the safety warnings below may result in severe injury, death or property damage. READ AND FOLLOW ALL INSTRUCTIONS This is the safety-alert symbol.
Carefully read the operation instructions and warning Wi-Fi Connected Model document first. • Assemble the caddy cart (if included with product). AquaVac Connect Download and install the Hayward AquaVac Connect Application on your mobile device. For Wi-Fi Connected Cleaner Version Only...
Pool Preparation pH: 7.2 - 7.8 Chlorine: 1.0-3.0 PPM Total Alkalinity: 80 - 120 PPM 50˚- 100˚F 10˚- 37˚C >3.0 PPM POOL PREPARATION CAUTION - RISK OF EQUIPMENT DAMAGE • NEVER SWIM WITH THE CLEANER IN THE POOL. The cleaner is not intended to clean the pool after extended periods of disuse until the following steps have been taken: •...
Page 5
Control Unit Set-Up 2.75”/69.85mm INSTALL The AquaVac 6 Series Control Unit can be installed and • Leaving the control unit on the pool deck is acceptable but used in different locations: precautions should be taken so it does not get damaged by regular traffic around the pool or by playing children or pets.
CLEANER LOCATION • It is ideal to have the control unit positioned near the midpoint of your pool (lengthwise). • Depending on the size and shape of your pool, the entire length of the floating cable may not be necessary. The floating cable should reach from the cleaner control unit to the furthest point in the pool, plus the depth at the deep end of the pool.
START *STOPS* • To avoid risk of damage or injury, the cleaner will not CLEANING CYCLE operate when out of the water. It is equipped with sensors that will allow it to recover from beach entry style pools or • During its cleaning cycle the cleaner may not climb the wall shallow areas.
Page 8
CLEANING THE DEBRIS CANISTER Some water is kept in the canister to enable the self-cleaning and flushing function for a true touch-free debris disposal. If desired, most of the water can be removed from the canister by simply tilting it toward the suction inlet check-valve. Doing so may result in having to rinse the canister after CLICK flushing the debris.
Page 9
Control Unit Interface AV6 WI-FI Schedule Mode Cleaning Mode Start/Stop Wi-Fi LED Canister Full LED Single Cleaning Cycle Weekly Calendar Cycle Recurring Cycle Waterline Only Floor Only Full Cycle...
Page 10
Control Unit Message AV6 WI-FI No Power No Communication Sleep Stand-By Cleaning Thermal Management Mode Error Fault Software Update Tug & Catch In Progress Direct Drive Spot Clean...
Control Unit Wi-fi Message AV6 WI-FI No Power Wi-fi Not Connected Wi-fi Connected No Wifi ADDITIONAL FUNCTIONS > Press Start/Stop button for 3 seconds Put cleaner to sleep > 2. Press Schedule Mode button for 3 seconds Light Down (dim) >...
Page 12
TS IEC 60364-7-702 Use Only Genuine Hayward Replacement Parts N’utilisez que des pièces détachées d’origine Hayward Utilice únicamente piezas de repuesto originales de Hayward Utilizzare esclusivamente pezzi di ricambio originali Hayward Verwenden Sie nur Original-Ersatzteile von Hayward Gebruik uitsluitend originele Hayward-onderdelen Utilize apenas peças sobresselentes de origem Hayward...
Need help?
Do you have a question about the AquaVac 6 Series and is the answer not in the manual?
Questions and answers