Table of Contents
Advertisement
Reload the Ultrastar Memory Drive Software
8.2
Installing Ultrastar Memory Drive Software to a Different
Bootable Media
After following the steps mentioned above to load the Ultrastar memory drive
software on the NVMe device, proceed with the following steps:
1.
Insert a bootable flash media to the system (such as USB flash drive).
2.
Ensure the bootable flash media is unmounted.
3.
Install the Ultrastar memory drive software to the bootable flash media (See
Figure 8.2, found below).
4.
Set the system BIOS to boot from the bootable flash media.
5.
Software reload is complete. Reboot the system to expand system DRAM
with Ultrastar memory drives.
- 41 -
Advertisement
Table of Contents
