Table of Contents
Advertisement
8.0 R
ELOAD THE
The Ultrastar memory drives were shipped pre-installed with software. If the software
was removed, deleted, or became corrupted, or if it is required to install the software
on a different bootable device, follow the steps listed in the below sections.
8.1
Reload to Ultrastar Memory Device
NOTE: Back up all data before beginning the software setup. Ultrastar memory
drive software configures the PCIe-based devices as a part of main (volatile)
memory pool.
The software installer can be obtained from the download section of the product
support page:
https://www.westerndigital.com/support/wdc/data-center-drives/ssd/ultrastar-dc-me200
Install the Ultrastar memory drive software to the Ultrastar memory device.
1.
If the system is capable of booting directly from the Ultrastar memory device
(using UEFI), set the system BIOS to boot from one of the Ultrastar memory
devices (if not, skip to the next section).
2. Software reload is complete. Reboot the system to expand system DRAM with
Ultrastar memory drive.
3. If your system fails to boot, you may try booting from a different bootable
media as is described in the following section.
Reload the Ultrastar Memory Drive Software
U
M
LTRASTAR
EMORY
D
S
RIVE
OFTWARE
- 39 -
Advertisement
Table of Contents
