Table of Contents
Advertisement
Ultrastar Memory Drive Boot, Settings and Diagnostics Menu
At this stage, the system displays configuration information. This specific example
shows:
1 x 2 Processor System ("Board") with 768GiB RAM (of which 728GiB are
available for use).
2 x NVMe SSDs ("Boards") with 1,788GiB each (of which 1,044GiB each are
available for use).
The system reports a total of 2,816GiB available for use.
Warning messages, if any (displayed in yellow font), notify the user about
deviations from best practices and recommendations.
A prompt is displayed to optionally enter the Ultrastar memory drive
settings and diagnostics menu (displayed in yellow font) by pressing <F5>
key. If no action is taken, after timeout, the Linux OS will be booted from
the device defined in the Ultrastar memory drive configuration.
Figure 3-3. Configuration Display
Guest OS Loads
Figure 3-4. Guest OS Loads
- 15 -
Advertisement
Table of Contents
