Run Test - FALEX 400 Operation And Maintenance Manual

Section 3: Software Operation
23
Lower Left and Right Buttons
Figure 29
The 'Instructions' button pops up a window to help ex-
plain how the current procedure is run
instructions are basic and the user should refer to other
sections in this manual for a more detailed explanation
on that particular procedure. Some instructions may
have multiple pages and the arrow in the lower right cor-
ner takes you to additional instructions. Press the 'Close'
button to exit the instructions and return to the program.
Additional Page Arrow
Figure 30
on Instruction Pages
Throughout various screens will be 'factory' buttons.
'Factory' buttons are solely for the use of authorized
factory personnel and access to this area is protected.

3.2 Run Test

If this is the initial setup or if the unit
has not been operated for 15 days it is
recommended that the automated Purge be
run prior to any tests being performed on
the unit. Refer to section 6.3.3.
The 'RUN TEST' menu allows users to choose various
test types. The test data can be viewed, printed, and/or
stored after a successful test completion.
Instructions
1. Accessing the Test Type screen: On the MAIN
screen press the 'Run Test' button
Forward
button is not visible there will be a temperature bar
screen
in its place
and back
heater tube thermocouple temperature and will
screen
not allow an operator to start a new test until the
buttons
temperature drops below 40ºC, at which time it is
safe to remove the old heater tube and set up for
a new test.
. These
[Figure 30]
Additional
pages
Figure 31
Ready State
Figure 32
. This bar shows the current
[Figure 32]
The heater tube test section is extremely
hot and dangerous to handle during and
after a test has completed or aborted. Keep
the thermocouple in the heater tube after
any test has completed or aborted until its
temperature drops below 40ºC. Once the
temperature is below 40ºC the unit is safe
to handle.
Main Screen In
Main Screen Waiting For Heater
Tube Temperature to Lower
. If this
[Figure 31]
Access
Test
Selection
Screen
Temperature
must be
below 40ºC
before 'Run
Test' button
appears