Table Of Contents; Introduction; Step 1-Inspect Shipment - Trane 4WHC3036 Installer's Manual

Contents
Safety Considerations. ................................................2
Introduction............. .....................................................3
Step 1-Inspect Shipment............ ..............................3
Step 2-Determine Unit Clearances........ ..................4
Step 3-Review Location and Recommendation Infor-
mation............. ..............................................................6
Step 4-Unit Installation............. ................................6
Ground Level Installation............ ...............................6
Lifting and Rigging............ ..........................................7
Rooftop Installation -- Frame Mounting............. .......7
Rooftop Installation -- Flat Roof - No Frame............. 7
Ductwork Installation............. .....................................7
Condensate Drain Piping............. ...............................9
Air Filters............. .........................................................9
Electrical Wiring ........................................................10
Electrical Connection ................................................10
Electrical Power .........................................................10
Disconnect Switch .....................................................10
Power Wiring ..............................................................10
Accessories ...............................................................10
Control Wiring (Class II) ............ ...............................10
Starting the Unit............ .............................................11
Pre-Start Quick Checklist........... ..............................11
Starting the Unit In the Cooling Mode............ .........11
Operating Pressures .................................................11
Voltage ........................................................................11
Cooling Shut Down ...................................................11
Starting the Unit in the Heating Mode............ .........11
Heating Shut-Down ...................................................11
Sequence Of Operation............ .................................12
General............ ...........................................................12
Cooling Mode............ .................................................12
Heating Mode............ .................................................12
Supplementary Heat............ ......................................12
Demand Defrost Operation........... ............................12
Final Installation Checklist............. ..........................14
Maintenance............. ..................................................14
Owner Maintenance............ .......................................14
Service Maintenance ............ ....................................14
DEFROST CONTROL............. ....................................15
Base Limited Warranty............ ..................................18
Installer's Guide

Introduction

Read this manual carefully before attempting to install, operate, or perform mainte-
nance on this unit. Installation and maintenance should be performed by qualified
service technicians only.
Packaged units are designed for outdoor mounting with a vertical condenser dis-
charge. They can be located either at ground level or on a roof in accordance with
local codes. Each unit contains an operating charge of refrigerant as shipped.
This guide is organized as follows:
• Step 1 - Inspect Shipment
• Step 2 - Determine Unit Clearances
• Step 3 - Review Location and Recommendation Information
• Step 4 - Unit Installation
• Step 5 - Unit Startup
• Sequence of Operation
• Maintenance

Step 1-Inspect Shipment

1. Check for damage after the unit is unloaded. Report promptly to the carrier any
damage found to the unit. Do not drop the unit.
2. Check the unit's nameplate to determine if the unit is correct for the intended ap-
plication. The power supply must be adequate for both the unit and all accessories.
3. Check to be sure the refrigerant charge has been retained during shipment using
the 1/4" flare pressure taps located near the blower panel on the side of the unit.
NOTE: If practical, install any internal accessories to the unit at the shop.
Page 3