Selecting A Flash Mode - Sony DSC-U60 Operating Instructions (primary manual) Operating Instructions Manual

SELFTIMER
2.0M 2.0M 2.0M
O N
O F F
EXEC
3
, Select [ON] with the control
button v, then press EXEC.
When you press MENU, the menu
disappears and the (self-timer) indicator
appears on the LCD screen.
• When placing the camera in a standing
position, make sure the LCD screen is level.
101
10
4
, Center the subject in the LCD
screen and press the shutter
button fully down.
The self-timer lamp flashes red and a
continuous beep sounds. The image will be
shot after approximately 10 seconds.
To cancel the self-timer in the middle
of the operation
Press POWER to turn off the power.
• If you press the shutter button while standing in
front of the camera, the focus and the exposure
may not be correctly set.

Selecting a flash mode

101
2.0M 2.0M 2.0M
10
Self-timer lamp
, Set the mode switch to
press the control button v ( )
repeatedly to select a flash
mode.
Each time you press v ( ), the indicator
changes as follows.
No indicator (Auto): Based on the
lighting conditions, the camera will decide
if there is enough light, and will use the
flash accordingly.
(Red-eye reduction): Flash mode is
set to Auto, and the red-eye reduction
operates if the flash strobes.
(Forced flash): The flash strobes
regardless of the surrounding brightness.
(No flash): The flash does not strobe.
101
2.0M 2.0M 2.0M
10
, and
25