Advertisement
Step 8
BE19
The main frame pieces reinforce the
walls and roof. These pieces will later
be installed in the center of the roof
and at the top edge of the rear wall.
Proceed as follows:
1
Overlap the roof beam pieces as
shown in the gure (large hole on top)
and fasten the two pieces together
with four bolts and nuts where shown.
2
Overlap the rear wall angle pieces
as shown in the figure and fasten
them together with four bolts and
nuts where shown.
3
Set the assemblies aside. You will
use them later.
Parts Needed For
Roof Beam/Rear
Wall Angle Assembly
STEP
9883
Rear Wall Angle Assembly
9885
Roof Beam Assembly
2
9883
19
9885 Roof Beam (2)
9883 Rear Wall Angle (2)
STEP
1
9885
Advertisement
