Table of Contents
Advertisement
5-1-4 Setting the Addresses of the Recipient
To monitor and operate the unit with the maintenance tool via
mail from a remote location, enter the mail address of the
receiver in the [Mail Communication Setting].
A maximum of 10 addresses can be registered.
E-mail communication is possible only with the recipients
whose addresses are registered on this screen.
5-1-5 Mail format
Error mails are sent in the format shown below.
Item
Mail title
Set title
From
GB-24A unit name and unit ID
Date
dd/MM/yyyy hh:mm:ss
When an error occurs on air conditioners and
Error unit
general equipment
- M-NET address of the error source
Error code
4-digit error
Status
"Occurrence" or "Recovery"
From:Mitsubishi Building(000001)
Date:11/09/2005 16:32:12
Error unit:065
Error code:1302
Status:Occurrence
Format
21
Remarks
Refer to 5-1-3 (1) for the setting of mail title.
Refer to 4-2-1 for the setting of GB-24A unit
name and unit ID.
Date of error
Note: The date format set in section 4-2-5 will be
applied.
Note: When an error occurs on the general
equipment that is connected via DIDO
controller, M-NET address of the DIDO
controller will be sent. (which means an error
occurs on one of the general equipment that is
connected to the DIDO controller)
When an error occurs on air conditioners
Refer to the service manual for each unit.
When an error occurs on general equipment
0091:General equipment error
Error status
Advertisement
Table of Contents
