Table of Contents
Advertisement
Fault
Possible cause
Cleaning effect inad-
None or too little detergent, none or too little
equate
air pressure in the supply line, worn brushes
Too little water or
Dirt catcher is blocked, water pressure insuffi-
none is coming out of
cient, jets blocked, magnet valve or supply line
the jets.
defective
Water still comes out
Magnet valve dirty
of the jets after the
end of the wash
Drying insufficient
Too little or too much drying aid, false drying
aid, none or too little air pressure
Brushes dirty fast
Shampoo dosage too low
Plant without function Fault in the voltage supply
Portal is driven out
Limit switch falsely set
beyond limit switch
for the ends of the
drive-rails
EU Declaration of Conformity
We hereby declare that the machine de-
scribed below complies with the relevant
basic safety and health requirements of the
EU Directives, both in its basic design and
construction as well as in the version put
into circulation by us. This declaration shall
cease to be valid if the machine is modified
without our prior approval.
Product:
Washing plant
Type:
1.534-xxx
Relevant EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
Applied harmonized standards
EN ISO 12100
EN 60204–1
EN 55014–2: 2015
(Limit Class A)
EN 61000–3–3: 2013
Applied national standards
The signatories act on behalf of and with
the authority of the company management.
Chairman of the Board of Management
Director Regulatory Affairs & Certification
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Straße 28-40
71364 Winnenden (Germany)
Tel.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2019/01/01
24
Faults without display
Remedy
Check filling level of the detergent; if necessary fill up;
vent dosing pumps. Check air pressure, if necessary
adjust (0.5 Mpa (5 bar) at the manometer mainte-
nance unit). Clean detergent suction, check detergent
supply lines for damage, check brushes and if neces-
sary replace.
Clean dirt catcher, check water supply pressure and
pumps, clean jets with compressed air, service mag-
net valves and supply lines (water and electricity) if
necessary.
Clean magnet valves.
Increase or decrease dosage, check filling level of the
detergent, clean suction filter, vent dosing pump, use
original drying aid by Kärcher.
Adjust shampoo, check water amount, adjust if nec-
essary.
See to fault-free voltage supply according to connec-
tion values.
Check distance between limit switch and switch flag
(nominal: 4mm).
Warranty
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of your accessory within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication. In the event of a warran-
ty claim please contact your dealer or the
nearest authorized Customer Service cent-
er. Please submit the proof of purchase.
Spare parts
Only use accessories and spare parts
–
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.
At the end of the operating instructions
–
you will find a selected list of spare
parts that are often required.
For additional information about spare
–
parts, please go to the Service section
at www.kaercher.com.
22
-
EN
of whom
Operator
Operator
Customer
Service
Operator
Operator
Operator/
Electri-
cians
Operator/
Customer
Service
Hide quick links:
Advertisement
Table of Contents
