Pf Key Tab - Kenwood TKR-750 Programming Reference Manual

Table 6-5 The Transmitting channel during Scan.
Transmission event During the Scan
AUX In & In (I/O)
AUX Out
Air Remote Transpond
Note:
! The Transpond code is sent while the scan operation is
pausing.
! The Transpond code is sent on the Revert CH when the
Scan operation is switched On by the Air Remote.
6.9.1

PF Key Tab

On this tab, It can configure the Air Remote code
assigned to PF keys controlled.
Figure 6-17 "PF Key" tab
" Function (PF Key)
The function configured on the "Key Assignment"
window appears. However, you cannot change the
configuration on this window.
Assignment Window.)
" Activation (PF Key)
This is a standby Air Remote code to be decoded in
order to activate the assigned function for the PF key.
From the dropdown list, you can select a table number
in the "Decode" tab from "Encode/Decode" table
window. (Refer to 6.8 "Encode/Decode Table"
Window.)
Range None, Dec. Table 1 - 40
Default None
Note:
! You cannot configure the "Activation" if no function is assign
(Refer to " Function (PF Key).)
to "Function".
! When Dec. Table is already used in other functions, you
cannot configure the same Dec. Table.
Version: 1.01
While the Scan
pauses.
Revert CH Revert CH
CH that Scan
Revert CH
pauses
CH that Scan
-
pauses
(Refer to 6.5 Key
Field Programming Reference (FPRG)
" Deactivation (PF Key)
This is a standby Air Remote code to be decoded in
order to deactivate the assigned function for the PF
key. From the dropdown list, you can select a table
number in the "Decode" tab from "Encode/Decode"
table window. (Refer to 6.8 "Encode/Decode Table"
Window.)
Range None, Dec. Table 1 - 40
Default None
Note:
! You cannot configure "Deactivation" if no function is assign
(Refer to " Function (PF Key).)
to "Function".
! You cannot configure "Deactivation" to the functions that it
cannot be disable, such as Channel Up function.
! When Dec. Table is already used to other functions, you
cannot configure the same Dec. Table.
" Transponder (PF Key)
This is a timing to send the Transpond code. Select
one of "None", "Fore", "After" and "Both" from the
dropdown list.
None Not send the Transpond code.
Sends the Transpond code when
Fore
receiving the Air Remote code.
Sends the Transpond code after
Range
After
processing the received Air Remote code.
Sends the Transpond code when
Both receiving the Air Remote code and after
processing the received code.
Default None
Note:
! You cannot configure "Transponder" if no function is assign
(Refer to " Function (PF Key).)
to "Function".
! You may not be allowed to select "After" or "Both" due to the
assigned functions to the PF key. (Example: Reset, CW ID
On) (Refer to 6.5 Key Assignment Window.)
6 EDIT MENU
44