Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Base (cont.)
ASSEMBLING
1) Do the Reverse of the disassembling Steps.
2) After assembling Base to the machine, adjust the following portion for smooth adjustment of cut depth.
A. Pan head screw M5 in the Hinge portion of Base
Must be tightened so that the Machine can move along
Depth guide smoothly without rattling. (Fig. 3 and 4)
B. Lever 40
Must be installed so that it can be locked at an angle of
between 0 and 30 degrees from the Centerline towards
Switch side when the Cut depth is set to the Maximum.
(Fig. 5)
Also do Adjustment for Accuracy of 90 degree and
45 degree Cut. (See page 11 for details.)
[3] -2. Safety Cover Complete and Bearing Box Section
DISASSEMBLING
1) Remove Rubber sleeve. (Fig. 2)
2) By removing Retaining ring WR-26 with 1R212, the following parts can be removed (Fig. 6):
Flat washer 26, Safety cover, Tension spring 4, Thickness ring.
Note : Safety cover complete can be separated from Blade case by unhooking the end of Tension spring 4 from
Blade case.
3) By unscrewing two M5x16 Countersunk head screws, Bearing box section can be removed by hand. (Fig. 7)
If cannot be removed by hand, lever off using a pair of 1R263 as illustrated in Fig. 7A.
Note: It is recommended to use cordless impact driver for removing the screws because threadlocker is
applied to them.
Fig. 6
Blade case
Tension spring 4
Safety cover
1R212
Retaining ring WR-26
Thickness ring
Flat washer 26
Fig. 5
Depth guide
Base
Fig. 7
Bearing box
Countersunk head
screw M5x16
Fig. 7A
Bearing box section
1R263
P 4 /14
30 degrees
Center line of Handle
Lever 40
1R263
Advertisement
