Testing Switching Outputs - Viessmann Vitotrol 100 UTDB-RF2 Installation And Service Instructions Manual
Room temperature controller with digital time switch and wireless receiver for the vitodens 100-w
Hide thumbs
Also See for Vitotrol 100 UTDB-RF2:
- Installation and service instructions manual (16 pages)
Table of Contents
Advertisement
Commissioning
Commissioning the wireless receiver
Testing switching outputs
1. Press
on the wireless receiver (see diagram on
B
page 11) repeatedly until the required condition is
reached (see following table).
Function
Central heating and DHW heating OFF
Central heating OFF, DHW heating enabled
Central heating enabled, DHW heating OFF
Central heating and DHW heating enabled
Note
Both switching outputs are enabled for heat demand if
the receiver does not pick up any signal from the
Vitotrol 100 for more than 60 min.
12
(cont.)
2. Terminate the function:
Press
B
.
LED
Off
Off
ON
ON
LED
r
Off
ON
Off
ON
Hide quick links:
Advertisement
Table of Contents
