Sony Cyber-shot DSC-L1 Operating Instructions Manual page 105

Message
For "InfoLITHIUM" battery
only
Image size over
Cannot divide
Invalid operation

Turn the power off and on
again
640(Fine) is not available
Enable printer to connect
Connect to device
No printable image
Printer busy
Paper error
Ink error
Printer error
Meaning/Corrective Action
• The battery pack is not the "InfoLITHIUM" type.
• You are playing back an image of a size that cannot be played back on your camera.
• The movie is not long enough to be divided (about more than two seconds).
• The file is not a movie.
• You are playing back a file that was created on equipment other than this camera.
• The battery level is low or zero. Charge the battery pack (page 13). Depending on the conditions of use or the type
of battery pack, the indicator may flash even though there are still 5 to 10 minutes of remaining battery time left.
• Camera shake may occur due to insufficient light. Use the flash, mount the camera on a tripod, or otherwise
secure the camera in place.
• A problem with the lens caused an error.
• 640(Fine) size movies can be recorded only using "Memory Stick PRO Duo". Insert a "Memory Stick PRO Duo"
or set the image size to other than [640(Fine)].
• [USB Connect] is set to [PictBridge], however the camera is connected to a non-PictBridge compliant device.
Check the device.
• Depending on the circumstances, the connection may not be established. Disconnect and connect the USB cable
again. If an error message is indicated on the printer, refer to the operating instructions supplied with the printer.
• You tried to print images before the printer connection was established. Connect to a PictBridge compliant printer.
• You tried to execute [DPOF image] without checking the
• You tried to execute [All In This Folder] while selecting the folder that stores only movies. You cannot print
movies.
• Since the printer is busy, it cannot receive print requests. Check the printer.
• A paper error occurred, such as paper-out, paper-jam, etc. Check the printer.
• An ink error has occurred in the connected printer, or the ink is low. Check the printer.
• The camera received an error from the printer. Check the printer, or check if the image you want to print is
corrupted.
• The data transmission to the printer may not be completed yet. Do not disconnect the USB cable.
mark.
105