Hama TS33C Operating Instructions Manual page 5

Note
• When installing the measuring
station, ensure that it is protected
from direct sunlight and rain.
• The international standard height for
measuring air temperature is 1.25 m
(4 ft) above ground.
Warning
• Buy special or suitable installation
material from a specialised dealer
for wall-mounting.
• Ensure that no faulty or damaged
parts are installed.
• Never apply force during installation.
This could damage the product.
• Before installation, ensure that
the chosen wall is suitable for the
weight to be installation, and make
sure that there are no electrical
wires, water, gas or other lines in the
wall at the installation site.
• You can position the measuring station
on a level outdoor surface using
the base.
• We recommend installing the
measuring station securely on an
outdoor wall.
• Install an anchor, screw, nail, etc. in the
wall of your choice.
• Hang the measuring station using the
opening intended for this purpose (5).
4
6. Operation
6.1. Default setting
• After opening the battery compartment,
first choose the channel using the
CHANNEL button.
• Only then, insert the batteries into the
battery compartment with the correct
polarity.
• Press the RESET button.
• Then replace the battery compartment
on the outdoor sensor.
6.2. Connection to the measuring
station
• To connect the measuring station and
the outdoor sensor, place the two
devices as close together as possible.
• After you insert the batteries, the base
station automatically searches for a
connection to the measuring station
and performs initial setup.
• If the device does not connect
automatically, the manual search
program on the base station must
be started.
Note
• Initial setup takes approx. 2 minutes.
• During the connection attempt, the
measuring station radio symbol (1)
will flash.
• Do not press any buttons during
setup. Otherwise, values may not be
transmitted correctly and there is a
risk of value errors and inaccuracies.