Mounting Power Head To Ceiling - beamUP 2211-U Product Manual

MOUNTING POWER HEAD TO CEILING

Look in the box for:
4 x Lag Screw
5/16" x 1-1/2" / /
4 x Flange Nut Hanging Brackets
WARNING
To prevent SERIOUS INJURY:
• DO NOT connect power until instructed.
• Install the opener at least 7 feet (2.13m) above the
floor.
• Fasten the opener SECURELY to STRUCTURAL
SUPPORT of the garage to prevent falling.
• If installing brackets to masonry, concrete anchors
(not provided) MUST be used.
4 x Bolt
5/16 5/16" - 18 x 1" 18 x 1
(not supplied)
Raise power head and place it on top of step
ladder. Position and align power head with
rail assembly to centerline.
Fasten angle iron to stud
under a finished ceiling.
Raise power head to measure
distance from each side, rail
must be horizontal.
Angle
Iron
Three most common installation options. Determine the mounting
option that works best for you.
Cut both hanging brackets to
appropriate length. Secure
opener from each side to
hanging brackets with 5/16"
x 1 bolt.
Need rewritten text
Structural Support
Raise power head and secure
one end of each hanging bracket
to angle iron with 5/16" x 1 bolt.
Open door manually to check
clearance between highest point
of travel of door and rail.
Open
beamLabs.io 1-800-436-9186
11