Advertisement
Appendix A
Memory Upgrade Instructions for Firepower Management Centers
Before working on a system that has an On/Off switch, turn OFF the power and unplug the power
Warning
cord. Statement 1
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment
in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Read the installation instructions before connecting the system to the power source. Statement
Warning
1004
Ultimate disposal of this product should be handled according to all national laws and
Warning
regulations. Statement 1040
Removing the Chassis Cover
Firepower Management Centers have covers that slide off the rear of the chassis. There are slight
differences between chassis models which are described in the following sections:
•
•
Removing the Cover from Firepower Management Center 750
The procedure for removing the cover from a Firepower Management Center 750 differs depending on
the revision of the appliance (Rev. 1 or Rev. 2). See
chassis. See
To remove the cover from a Firepower MC750:
Note
A nonskid surface or a stop behind the MC750 (Rev. 1 or Rev. 2) may be needed to prevent the device
from sliding on your work surface.
Removing the Cover from Firepower Management Center 750, page A-3
Removing the Cover from Firepower Management Center 1500 and 3500, page A-5
Figure A-2
for an illustration of the MC750 Rev. 2 chassis.
Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation Guide
Removing the Chassis Cover
Figure A-1
for an illustration of the MC750 Rev. 1
A-3
Advertisement
