Setting Up The Tv - Sony WEGA KD 32FS130 Operating Instructions Manual

Setting Up the TV

After you have finished connecting your TV, use Auto Program to set up your analog and
digital channel lists. During Auto Program, the TV will automatically search for available
channels and program receivable channels.
✍
After starting Auto Program, wait until the process is complete to avoid missing some channels that
are available. To re-program receivable channels, run Auto Program again as described on page 42
(analog channels) and page 55 (digital channels).
1
Press the button to turn on the TV.
POWER
The Initial Setup screen appears.
2
Press the button on the remote control or on the TV front panel to start Auto Program,
CH+
or press the button to exit.
CH-
✍
The Initial Setup screen appears each time you turn on the TV until you perform Auto Program.
Auto Program automatically creates a list of receivable analog channels. When completed,
a screen prompts you to continue searching for digital channels.
Searching for digital channels may take 50 minutes or more to complete. A progress bar is
displayed while the channel list is being created.
3
When Auto Program is finished, the lowest numbered channel is displayed.
To run Auto Program again at a later time
❏
Use the Auto Program feature, using the TV's menus. For analog channels, see page 42.
For digital channels, see page 55.
To add digital channels
❏
Use the Digital Channels/Add feature, as described on page 55.
To reset the TV to factory settings
1
Turn the TV on.
2
RESET
Hold down on the remote control.
3
Press and release the
back on.
4
RESET
Release .
button on the TV front panel. The TV will turn itself off, then
POWER
27