Inspur NF5166M4 User Manual page 55

BIOS Setup
1) Set static BMC network parameters
Set the Configuration Address Source option to [Static], if the setting is successful,
it will prompt "Set Static BMC IP Address Source Success!!", and BMC network will
become static immediately.
Select the Station IP Address option, and press Enter, the Station IP Address window
will pop up, manually enter the Static IP to set, after configuration is completed,
press Enter to confirm, and an example is as shown in the following figure:
If the setting succeeds, it will prompt "Set Static BMC Station IP OK!!!", and the
setting takes effect immediately.
If the setting fails, it will prompt "Set Static BMC Station IP Fail!!!";
If the IP doesn't change, it will prompt "Static BMC Station IP Not Change!!!";
If the input IP is invalid, it will prompt "Invalid Station IP Entered!!!", and assign 0.0.0.0
to the IP address. This assignment just changes the IP address in BIOS setup
interface, and does not send IPMI command to change the BMC IP.
The setting prompts of Subnet mask and Router IP address are similar with those
of Station IP address, and will not be repeated here. After setup, BMC network
parameters will take effect, users can login the BMC Web interface to operate.
51