Data To Be Transferred Over The Bus - ABB SPAJ 160 C User Manual And Technical Description

Data to be
transferred
over the bus
Code Event
E25 Output signal TS1 activated
E26 Output signal TS1 reset
E27 Output signal SS1 activated
E28 Output signal SS1 reset
E29 Output signal SS2 activated
E30 Output signal SS2 reset
E31 Output signal SS3 activated
E32 Output signal SS3 reset
E33 Output signal TS2 activated
E34 Output signal TS2 reset
Default checksum for mask V158
E50 Restarting
E51 Overflow of event register
E52 Temporary interruption in data communication
E53 No response from the module over the data communication
E54 The module responds again over the data communication
0 Not included in the event reporting
1 included in the event reporting
* No code number
- Cannot be programmed
Note!
The eventcodes E52...E54 are only generated
by the datacommunicator unit. (SACO 100M,
SRIO 1000M etc.)
In addition to the event data transfer the SPA-
bus allows reading of all input data (I-data) of
the module, setting values (S-data), information
recorded in the memory (V-data), and some
Data
INPUTS
Filtered current measured on phase L1
Filtered current measured on phase L2
Filtered current measured on phase L3
Compensated unbalance current ∆I
Measured unbalance current ∆I
Blocking or control signal BS1
Blocking or control signal BS2
Blocking or control signal RRES
other data. Further, part of the data can be al-
tered by commands given over the SPA-bus. All
the data are available in channel 0.
Code Data flow Value range
direction
I1 R
I2 R
I3 R
I4 R
c
I5 R
I6 R
I7 R
I8 R
Number Default value
representing of the factor
the event
1 0
2 0
4 0
8 0
16 0
32 0
64 0
128 0
256 256
512 512
768
* -
* -
* -
* -
* -
0...8.5 x I
n
0...8.5 x I
n
0...8.5 x I
n
0...232% x ∆I
n
999 = Unbalance prot.
inhibited
0...212% x ∆I
n
0 = no blocking
1 = BS1-signal active
0 = no blocking
1 = BS2-signal active
0 = no blocking
1 = RRES-signal active
23