Siemens Simatic S7-200 CPU 210 System Manual page 59

Refer to Figure 3-19 and follow these steps to enter a vertical line and to copy the output coil
from the first rung:
1. Move the cursor to the horizontal line above the contact for "Armed" (or I0.2). Click the
F7 toolbar button to insert a vertical line that connects the first rung with the second rung.
2. Move the cursor to the output coil on the first rung. Use the menu command Edit
to copy the output coil to the clipboard.
3. Move the cursor down and use the menu command Edit
coil. Type Modem (or Q0.3) in the highlighted field and press ENTER. Press ENTER
again to accept the default value of 1.
Lines
Network 1
"Panic_Alarm"
"Alert_Timer"
>=I
+600
Output Coils
Network 1
"Panic_Alarm"
"Alert_Timer"
>=I
+600
Output Coils
Network 1
"Panic_Alarm"
"Alert_Timer"
>=I
+600
Figure 3-19 Entering a Vertical Line and Copying the Output Coil
S7-200 Programmable Controller, CPU 210
C79000-G7076-C235-01
Getting Started with a Sample Program
Vertical
F2
Sound the alarm!
Position the cursor on
the top rung of the
network.
"Alarm_Bit"
S
1
"Armed"
Set
F2
Sound the alarm!
"Alarm_Bit"
S
1
"Armed"
Set
F2
Sound the alarm!
"Alarm_Bit"
S
1
"Modem"
"Armed"
S
1
Paste to paste the output
F3
F4 F5 F6 F7 F8
Click the toolbar button
to insert a vertical line.
F3
F4 F5 F6 F7 F8
Copy the Set instruction
by selecting the
Copy command from
the Edit menu.
F3
F4 F5 F6 F7 F8
Move the cursor vertically and
paste the instruction at the
cursor location. Use the
Paste command from the Edit
menu.
Enter the address (Q0.3 or
Modem) and press ENTER.
Press ENTER again to accept
the value (1).
Copy
F10
F10
F10
3-19