Operation; Selecting The Input Source - Sony XVM-H65 Operating Instructions (primary manual) Operating Instructions Manual

Operation

Selecting the input source

You can select the input source and colour system.
1
Press (POWER).
The power is turned on.
Tip
If your car has no ACC (accessory) position on the ignition key switch, and the POWER
SELECT switch is set to the B position, the monitor does not turn on by pressing
(POWER) on the card remote commander (page 6).
2
Press (INPUT) to select the desired input source.
Each time you press (INPUT), the indication changes in the following sequence:
B VIDEO 1
3 V
Press or
Press either button while the source indication (such as "VIDEO 1") is displayed.
When NTSC Video is selected
VIDEO1
NTSC
10
POWER
B VIDEO 2
v
to select PAL or NTSC colour system.
ATT
INPUT
VOL
INPUT
+
TOP MENU ALBUM
MENU
ENTER
–
ALBUM
When PAL Video is selected
VIDEO1
PAL
POWER
POWER
MENU
MODE
LIST
SETUP
DISPLAY
OFF
AUDIO SUBTITLE