Advertisement
a) If the engine is cold, set the throttle control to the
choke position.
b) If the engine is warm, do not set the throttle
control to the choke position.
4. Hold the engine brake handle against the handlebar.
5. Hold the starter rope handle with your right hand.
6. Slowly pull out the starter rope until you feel some
resistance.
7. Pull with force to start the engine.
To stop the product
•
To stop the engine, release the engine brake handle.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
8
•
If the engine does not stop, disconnect the ignition
cable from the spark plug.
To get a good result
•
Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
•
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
•
Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 5 .
1095 - 002 -
Hide quick links:
Advertisement
