Troubleshooting - Dirt Devil Quick & Light FD50035 Owner's Manual

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug cleaner before servicing.
PROBLEM POSSIBLE CAUSE
Cleaner won't
1. Power cord not firmly plugged
into outlet.
run
2. Blown fuse or tripped breaker.
3. Needs service.
Cleaner won't
1. Dirty Water Tank Door not
installed.
pick-up or low
suction
2. Dirty Water Tank is not installed
correctly.
3. Dirty Water Tank is full.
4. Dirty water passage clogged.
5. Foam filter is dirty.
Water escap- 1. Dirty Water Tank is full.
ing from
2. Dirty Water tank is not installed
Cleaner
correctly.
3. Clean Water Solution Tank not
installed properly.
Cleaner won't
1. Clean Water Solution Tank not
installed properly.
dispense
2. Needs service.
Cleaner 1. Hose is clogged.
attachments
won't pick up
2. Hose inlet clogged.
3. Dirty Water Tank is full.
Cleaner 1. Water supply hose not
attachments connected properly.
won't spray
Motor noise 1. The float in the Dirty Water Tank
becomes has been activated.
high-pitched

4. TROUBLESHOOTING

WARNING
!
13
!
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
3. Take to service center. To find nearest
location, visit our website at www.DirtDevil.
com or call 1-800-321-1134.
1. Insert Dirty Water Tank Door - Pg. 9.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 11.
3. Empty Dirty Water Tank - Pg. 10.
4. Clean Dirty Water Tank - Pg. 10.
5. Clean filter. Review Emptying & Cleaning the
Dirty Water Tank - Pg. 10.
1. Emptying Dirty Water Tank - Pg. 10.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 11.
3. Review Clean Water Solution Tank
Installation - Pg. 8.
1. Review Clean Water Solution Tank
Installation - Pg. 8.
2. Take to service center. To find nearest
location, visit our website at www.DirtDevil.
com or call 1-800-321-1134.
1. Remove hose and tools; remove obstruction
- Pg. 9.
2. Remove hose and clean inlet - Pg. 9.
3. Empty Dirty Water Tank - Pg. 10.
1. Connect trigger water supply connector and
base water supply connector - Pg. 9.
1. Review Emptying & Cleaning the Dirty Water
Tank - Pg. 10.