CHINT NVF5 Series User Instructions page 88

NVF5 Series User Manual
AI1 〉 AI2
35
36 Reserve
Current
37
Reach
6.11.3 Analog Input Function（AI）
NVF5 Series has 2 Analog Input terminals -AI1、AI2，with -10V ～ +10V、4mA ～
20mA，AI2 can select V or mA signal by Dip switch on the PCB board.AI setting
mode,See Parameter"6.2.3 Analog Main Frequency Setting".
6.11.4 Analog、Pulse Output Function（AO、HDO）
NVF5 Series has 1 AO，1 High Speed Pulse Output(HDO).
Code
F6.00 HDO Output Type
AO1 Output
F6.08 Selection
HDO
F6.09 Selection
AO1 Zero Bias Correction
F6.10 Factor
F6.11 AO1 Gain
HDO Max. Output Pulse
F6.12
Frequency
AO、HDO Terminal Function Description：
Values
0 No Applicable
1 Running Frequency
2 Setting Frequency
Ramp
3 Frequency
4 Output RPM
5 Output Current1
6 Output Current 2
Output Torque（Absolute）
7
8 Output Power
9 Output Voltage
Running Time
Name
Setting
Output Setting
Function
Reference
Chapter 6 Parameter Function Description
time, the output is effective.，Timer set by F8.33
When AI1 〉 AI2 ，Output effective
--
When accumulate running time is exceed
F8.34- Current Running Reach Time ，Output
effective.
Default Setting Range
0 ～ 1
0
0 0 ～ 36
0 0 ～ 36
（
0.0%
100.0）%
-10.0. ～ 10.00
1.00
（0.01 ～ 100.00）
10.00kHz
kHz
No Applicable
0～Max. Output Frequency
0～Max. Output Frequency
0～Max. Output Frequency
0～Max. RPM
0～2 times Inverter Rated Current
0～2 times Motor Rated Current
0～3 times Motor Rated Torque
0～2 2 times Motor Rated Power
0～1.2 times Inverter Rated Voltage
- 84 -
Description
See
～
-100.0
Table
Description
Below