Setup 7: Adjust The Tilt And Height - Sony SDM-S75 Series Operating Instructions Manual

• If "OUT OF RANGE" appears on the screen:
Reconnect the old display. Then adjust the computer's graphics
board within the following ranges.
Analog RGB
Horizontal
28–80 kHz
frequency
Vertical
48–75 Hz
frequency
1280 × 1024 or less
Resolution
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 18.
No need for specific drivers
The display complies with the "DDC" Plug & Play standard and
automatically detects all the display's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the display, the
setup Wizard may appear on the screen. If this is the case, follow the on-
screen instructions. The Plug & Play display is automatically selected so
that you can use this display.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the display, you can use it as is. You do
not need to set the vertical frequency to any particular high value.

Setup 7: Adjust the tilt and height

This display can be adjusted within the angles shown below.
Hold both sides of the LCD panel, then adjust screen
angles.
approx. 5°
Digital RGB
28–64 kHz
60 Hz
approx. 20°
10
approx.
175°
approx. 175°
When you use the height adjustable stand, the height adjust is also
available as below.
Hold both sides of the LCD panel, then adjust screen
height.
To use the display comfortably
Adjust the viewing angle of your display according to the height
of your desk and chair, so that light is not reflected from the screen
to your eyes.
Notes
• When adjusting the screen's angle, be sure not to crash it against any
objects around the display.
• Do not put any objects under the display when you adjust the height of
stand. It may get damaged by accident.
approx. 110 mm
11
(4 / inches)
32