Setting The Battery Type; Turning The Power On; Auto Power Off Function - Yamaha PSR-E360 Owner's Manual

NOTICE
• Connecting or disconnecting the power adaptor with batteries installed may turn the
power off, resulting in loss of data being recorded at the time.
• Make sure to set the battery type correctly (page 7).
• When battery power becomes too low for proper operation, the volume may be reduced,
the sound may be distorted, and other problems may occur. When this happens, make sure
to replace all batteries with new ones or already recharged ones.
NOTE
• This instrument cannot charge the batteries. Use only the specified charger device when charg-
ing.
• Power will be automatically drawn from the AC adaptor if an AC adaptor is connected while bat-
teries are installed in the instrument.

Setting the battery type

Depending on the battery type to be used, you may need to change the battery
type setting on this instrument. Alkaline (and manganese) batteries are chosen
by default. After installing new batteries and turning the power on, make sure to
set the Battery Type appropriately (rechargeable or not) via Function number
022 (page 14).
NOTICE
• Failure to set the battery type may shorten the amount of the battery life. Make sure to set
the battery type correctly.

Turning the Power On

Set [MASTER VOLUME] to the MIN position,
then press the [ ] (Standby/On) switch to turn
on the power.
Adjust the volume as desired while playing the
keyboard.
Press and hold the [ ] (Standby/On) switch for
about a second to set the instrument to standby
mode.
CAUTION
• Even when the [ ] (Standby/On) switch is in standby status, electricity is still flowing to
the product at the minimum level. Remove the electric plug from the outlet when the
instrument is not to be used for extended periods of time, or during electrical storms.
• Do not use the instrument for a long period of time at a high or comfortable volume level,
since this can cause permanent hearing loss.

Auto Power Off function

To prevent unnecessary power consumption, this instrument features an Auto
Power Off function that automatically turns the power off if the instrument is not
used for approximately 30 minutes. To disable the Auto Power Off function,
select "Off" in the Function settings (Function 021).
Setting Up
7
PSR-E360 Owner's Manual