2 Safety instructions • Please read this document prior to set-up of the unit� Ensure that the product is suitable for your application without any restrictions� • If the operating instructions or the technical data are not adhered to, personal injury and/or damage to property can occur�...
4 Function • The unit supports IO-Link� • The unit converts the measured signal into a temperature-proportional ana- logue signal� Depending on the parameter setting (→ 7) the output signal is at: 4���20 mA with setting [OU] = [I] or 20���4 mA with setting [OU] = [Ineg]�...
► Horizontal mounting recommended for high medium temperatures� ► Connect the unit to the process using a fixing element (adapter, clamp)� Information about the available adapters at www�ifm�com� ► Observe the instructions of the adapter� ► Use a lubricating paste which is suitable and approved for the ap- plication�...
The IO-Link interface enables direct access to the process and diagnostic data and provides the possibility to set the parameters of the unit during operation� In addition communication is possible via a point-to-point connection with a USB adapter cable� You will find more detailed information about IO-Link at www�ifm�com/gb/io-link�...
► Connect the unit via the IO-Link interface to a PC or PLC with suitable param- eter setting software� ifm offers an IO-Link interface for the connection of the sensor via USB port� 7.1 Adjustable parameters...
8 Operation After power on, the unit is in the Run mode (= normal operating mode)� 9 Technical data Technical data and scale drawing at www�ifm�com 10 Factory setting Factory setting User setting Factory setting (ASP and AEP) and the units (Uni) →...