Removing The Computer - PRG MBOX 2016 Hardware Manual

Removing the Computer

The Mac Pro computer can be removed to be cleaned or replaced, or to have additional peripherals plugged into it.
To remove computer:
Step 1. At the rear of the rack, disconnect all power, USB, Ethernet, and DVI cables from the rear left side of
the Sonnet xMac unit. Make sure to also disconnect the LEMO connector from the front of the Genlock
Controller, the 3.5mm plug from the back side of the Genlock Controller, and the FireWire cable between the
computer and the Power Relay unit.
Step 2. At the rear of the xMac unit, loosen the three retaining fasteners that hold the computer enclosure into the
xMac unit.
Step 3. At the front of the rack, remove the front panel. Refer back to
36.
Step 4. Carefully slide the computer enclosure out of the case, checking for cables or connectors that may become
caught. (Figure B-2).
Figure B-2: Computer Removal
"Figure B-1: Air Filter Removal"
MBOX® 2016 DUAL OUTPUT HARDWARE MANUAL
on page
37