Getting Started - Sony CPD-M151 Marketing Operating Instructions Manual

Step 1: Connect the monitor to the
computer
Turn off the monitor and computer before connecting.
Connecting to an IBM PC/AT or compatible
computer
to HD15
IBM PC/AT or
compatible
computer
to monitor output
If your PC system is not compatible with Plug &
Play (DDC1 and DDC2B)
This monitor uses the No. 9 pin in the video signal connector for
Plug & Play (DDC1 and DDC2B) compatibility. See page 21 for the
location of the No. 9 pin.
• If your computer accepts the No. 9 pin, use the supplied HD15
video signal cable.
• If your computer does not accept the No. 9 pin, please consult
your dealer for advice on obtaining an HD15 adapter.
Connecting to a Macintosh
Use the supplied Macintosh adapter.
Macintosh or
compatible computer
* Connect the supplied Macintosh adapter to the computer before
HD15 video
signal cable connecting the cable. This adapter is compatible with Macintosh
(supplied)
LC, Performa, Quadra, Power Macintosh and Power Macintosh
G3 series computers (sold before January, 1999). If you are
connecting to a Power Macintosh G3 series that sold after
January 1999, you will need a different adapter (not supplied).
Macintosh II series and some older versions of PowerBook
models may need an adapter with micro switches (not
supplied).
Step 2: Connect the power cord
With the monitor and computer switched off, connect one
end of the power cord to the AC power adapter, and the AC
power adaptor to the monitor. Then connect the other end o
the power cord to a power outlet.
to a power outlet
Power cord
(supplied)

Getting Started

Getting Started
to HD15
to monitor output
Macintosh adapter
(supplied)*
to DC IN
AC power adapter
(supplied)
HD15 video
signal cable
(supplied)
GB
F
D
ES
I
7