Definitions; General Safety Information - Emerson CBA730 Disassembly And Reassembly

Section 1: Introduction
August 2015
CAUTION: FOLLOW MANUFACTURER'S INSTRUCTIONS
Apply the thread sealant per the manufacturer's instructions.
1.1.10 Bettis recommends that disassembly of the actuator should be done in a clean
1�2

Definitions

If not observed, user incurs a high risk of severe damage to actuator and/or fatal injury
to personnel.
If not observed, user may incur damage to actuator and/or injury to personnel.
NOTE:
Advisory and information comments provided to assist maintenance personnel to carry out
maintenance procedures.
NOTE:
This product is only intended for use in large-scale fixed installations excluded from the
scope of Directive 2011/65/EU on the restriction of the use of certain hazardous substances
in electrical and electronic equipment (RoHS 2).
M3:
Jackscrew or jackscrew assembly
ES:
Extended Stop(s)
1�3

General Safety Information

1.3.1
For the protection of personnel working on Bettis actuators, this procedure should be
reviewed and implemented for safe disassembly and reassembly. Close attention should be
noted to the WARNINGS, CAUTIONS and NOTES contained in this procedure.
2
area on a workbench.
WARNING:
CAUTION:
Products supplied by Bettis, in its "as shipped" condition, are intrinsically safe if the
instructions contained within this Service Instruction are strictly adhered to and
executed by well trained, equipped, prepared and competent personnel.
WARNING: FOLLOW WARNING AND CAUTION SIGNS
Service Instructions
137462E Rev. D
Introduction