Subscribe to Our Youtube Channel
Related Manuals for WarmlyYours FeelsWarm
Summary of Contents for WarmlyYours FeelsWarm
- Page 1 WarmlyYours FeelsWarm® Countertop Heater Installation Instructions Free Design Service • 24/7 Installation Support • (800) 875-5285 • www.WarmlyYours.com...
- Page 2 However, the heater should be inspected periodically for damage or peeling. If either is present, immediately disconnect the power supply and contact WarmlyYours for technical support. Do not pull on the electrical cord connecting the heater to the power supply.
-
Page 3: Package Contents
If Surface Prep Kit is used: • Protective eyewear --REQUIRED • Gloves and appropriate clothing • Pencil • Dropcloth or other material to protect carpet or flooring under the countertop For large heating elements, WarmlyYours recommends having two people perform the installation. -
Page 4: Kit Contents
Surface Prep Coating. If the counter is “rough cut” natural stone, the WarmlyYours FeelsWarm® Surface Prep Coating will be necessary. As a general rule, a Surface Prep Kit will be needed if the heating mat is being applied to quartz, “rough” feeling granite underneath the counter, or supporting wood. - Page 5 The mixed epoxy will begin to harden in about 3-5 minutes. This is a very short time frame so brush on the epoxy fast with the primary focus on the perimeter of where the heating mat will be placed. IMPORTANT: If you have two kits included with your FeelsWarm mat, mix and apply one kit at a time. Applying the Coating 1.
- Page 6 Installation Instructions SECTION 2 2. PERFORM A TEST INSTALLATION OF THE HEATER BEFORE STARTING A. After the surface is prepared, conduct a preliminary fit by leaving the white release liner on the heater and holding the heater under the counter to ensure it fits as expected and that there are no conflicts with supports, doors, or other items. •...
- Page 7 Installation Instructions SECTION 2 3. DRILL CABLE HOLE IN CABINET A. Evaluate how the cable from the heater will reach the outlet inside the cabinet. Consider how the wire will feed and where an access hole needs to be located in order to route the heater cable within the framework of the cabinet. B.
- Page 8 Installation Instructions SECTION 2 4. ATTACH THE HEATING ELEMENT A. With the heating element lying on the top of the counter with the white release paper facing up, peel the white release liner off the heater— do not discard. B. Reduce the size of the release liner into manageable pieces by ripping the white release paper into smaller sections, approximately 6”...
-
Page 9: Install Power Supply
IMPORTANT: If the WarmlyYours FeelsWarm® system to be installed involves multiple transformers and/or multiple heating elements, each transformer plug and each heating element cable will have a numerical tag with matching code numbers. -
Page 10: Installation Instructions
8. SECURE WIRES Your WarmlyYours FeelsWarm® Countertop Heater is supplied with a packet of Velcro patches, a strap, and screws to secure the wires inside the cabinet. Because the length of the wires provided often exceeds what is needed, WarmlyYours recommends securing the wires to keep them out of the way of normal activity. - Page 11 To make operation easier and enhance your experience using your WarmlyYours FeelsWarm® Countertop Heater. WarmlyYours offers an optional 7-day programmable timer, allowing you to program 14 events or 2 ON-OFF cycles per day. The timer must be used on a GFCI protected circuit, as it does not have built-in GFCI protection.
Need help?
Do you have a question about the FeelsWarm and is the answer not in the manual?
Questions and answers