3 Insert a screwdriver under the back panel and remove
the panel.
4 Break the snap connections on both sides with the
screwdriver.
5 Push out the inner body by pushing the screwdriver into
the bottom of the handle. -
circuit board.
6 QP6510: remove the cover of the printed circuit board
with the screwdriver.
7 Remove the printed circuit board from the inner body
with the screwdriver.
8 Lift the battery out of the inner body with the
screwdriver. The battery is connected with double-sided
tape.
Warning: Be careful, the battery strips are very
sharp.
Warranty and support
If you need information or support, please visit
www.philips.com/support or read the international
warranty leaflet.
Now you see the printed