Advertisement
Tools required
Before beginning this procedure:
Switch off binary pump at the main power switch.
Disconnect the solvent inlet tube and the adapter at the active inlet valve.
Beware of leaking solvents due to hydrostatic flow.
Remove the solvent cabinet from the binary pump.
1 Remove front cover, top cover, metal plate
and top foam section. Remove the cover plate
that covers the position of the solvent
selection valve.
Installation Note for Solvent Selection Valve Upgrade Kit (G1360A)
Installing the Solvent Selection Valve Upgrade Kit
Installing the Solvent Selection Valve
Upgrade Kit
Screwdriver Pozidriv #1
Wrench 1/4 inch
Wrench 14 mm
Wrench 7 mm
Wrench 5 mm
The following procedure concentrates mainly on installation of new parts
and gives only basic information about preparation steps, such as top cover
removal, and so on. Refer to your Reference Manual in section "Repairing
Your Pump" for detailed descriptions of these procedures.
4
2 Disconnect capillaries, tubes and connectors
from the two pump heads and the damper.
Remove the mixing chamber from its holder.
Advertisement
