Turning On The Devices - Garmin Delta XC Series Owner's Manual

The status LED is solid red when the
collar is charging.
4
After the status LED turns solid green,
remove the charging clip from the
collar.
NOTE: The dog collar device returns to
factory default settings each time it is
charged or turned off.
Turning On the Devices
• On the handheld device, hold the
power key until the LCD display turns
on.
• On the dog collar device, hold the
power key until the status LED flashes
and the collar beeps.
Turning Off the Devices
• On the handheld device, hold the
power key until the LCD display turns
off.
• On the dog collar device, hold the
power key until the status LED flashes
and the collar beeps.
Pairing a Dog Collar Device with
the Handheld Device
NOTE:
If your handheld device and dog
collar device were included in the same
Quick Start Manual
package, the devices are paired from the
factory using the black color selection.
1
Turn on the dog collar device and the
handheld device.
2
On the handheld device, select:=: to
choose a color.
_.......indicates the selected color.
3
On the handheld device, select an
intensity level greater than 0
(page 8).
4
On the dog collar device, hold the
power key.
You must continue to hold the power
key during the pairing process.
The device beeps once when you
select the power key and again after
five seconds.
5
After the second beep, select a
training key on the handheld device.
The dog collar device turns off and beeps
to indicate whether the devices paired
successfully.
Short beep Devices paired successfully
Long beep Devices did not pair
TIP:
If the devices did not pair
successfully, you should verify the
5