Siemens SIMATIC S7 300 PLC Getting Started page 19

Sequence Activity
7 Set the "Synchronize drive with equidistant DP cycle", then set the time coefficients as shown below.
8 Click "Alignment".
9 Confirm with "OK".
10 Confirm the possible warning with "OK".
11 Finalize your HW configuration by calling the Station > Save
and compile command.
CPU 317T-2 DP: Controlling a SINAMICS S120
Getting Started, 12/2005, A5E00480391-01
3.6 6. Step: Configuring the drive in HW Config
Result
The following components are aligned to the
set values:
DP cycle in the DP master system
•
All drive components of the same family
•
(here SINAMICS
values.
The system compiles your project, and adds
the "Technology Objects" object to the
project window in SIMATIC Manager.
Learning units
) are aligned to the set
®
3-9