8. Technical data......................Declarations of conformity..................... Manufacturer reserves the right to make modifications in order to improve device operation. tel.: (12) 385 83 06 PXM Marek Żupnik spółka komandytowa fax: (12) 626 46 94 Podłęże 654 E-mail: info@pxm.pl 32-003 Podłęże Internet: www.pxm.pl...
1. GENERAL DESCRIPTION PX359 is a device to convert the DMX steering signal into the appropriate commands sent with the use of RS-232. The device is equipped with two independent buses RS-232, which various commands can be sent to. PX359 is programmed with the use of the web interface through the Internet browser without the need to install additional software and controllers.
3. DESCRIPTION OF THE DEVICE CONSTRUCTION PX359 is equipped with one Ethernet port, one DMX512 input, two RS-232 outputs, DIP switch to set a DMX address and signalling diodes. TOP OF THE DEVICE physical reset button signalling diodes DMX address -...
4.3. Dipswitch of the address The PX359 device has a physical dipswitch button which can be used to set its base DMX address. If the value 0 is set on the physical switch, the device accepts the DMX address saved in...
5. CONFIGURATION OF THE DEVICE The PX359 device enables to configure network settings, a DMX address, settings of the RS-232 signal and make a list of commands sent from the device. All the parameters can be configured by the web interface. Some parameters can also be set with the use of the RDM protocol.
Here, the MAC address of the device and the detected bandwidth are also visible. 5.4. DMX settings The PX359 device has a physical dipswitch button which can be used to set its base DMX address. If the value 0 is set on the physical switch, the device accepts the DMX address saved in memory.
NOTICE: the whole current configuration of the device will be overwritten. 5.9. Default settings PARAMETER VALUE 192.168.0.50 Gateway 192.168.0.1 Subnet 255.255.255.0 Device label PX359 Base DMX address Min. Duration time 2000 milliseconds COMn Baudrate 115200 bps COMn Data bits COMn Stop bits COMn Parity Lack...
5.10. RDM The PX359 supports the DMX-RDM protocol. DMX protocol allows only of a one-way data transmission, while its extension the RDM protocol can transmit information in two directions. This makes possible to simultaneously send and receive information, and hence the possibility of monitoring activities of the compatible devices.
Page 11
Parameter name Description SENSOR_VALUE 0x0201 information concerning sensors information concerning the working time of the DEVICE_HOURS 0x0400 device counted in hours a number of supply cycles which the device DEVICE_POWER_CYCLES 0x0405 registered restart of the device; 0x01 – saving a configuration and restarting RESET_DEVICE * 0x1001 the device (soft restart), 0xff –...
012 385 83 06 http://www.pxm.pl fax: 012 626 46 94 32-003 Podłęże DECLARATION OF CONFORMITY PXM Marek Żupnik spółka komandytowa Podłęże 654, 32-003 Podłęże declares under our sole responsibility that the product: Name of product: DMX - RS232 Interface Type:...
Need help?
Do you have a question about the PX359 and is the answer not in the manual?
Questions and answers