Force Cooling And Query - Bosch RDCI Series User Manual

6 | FORCE COOLING AND QUERY

6. FORCE COOLING AND QUERY
Force Cooling
■
Once the Force Cooling button has been pressed (see diagram), all the
indoor units will be forced into cooling mode and the fan speeds will be
running on maximum.
SW2 Display Codes
■
Table 6-1
No. Normal display
1 0. --
2 1. --
3 2. --
4 3. --
5 4. --
6 5. --
7 6. --
8 7. --
9 8. --
10 9. --
11 10. --
12 11. --
13 12. --
14 13. --
15 14. --
16 15. --
17 16. --
18 17. --
19 18. --
20 19. --
21 20. --
22 21. --
23 22. --
24 23. --
25 24. --
26 25. --
27 26. --
28 27. --
29 28. --
30 29. --
31 30. --
32 31. --
33 32. --
34 33. --
35 34. --
36 35. --
37 36. --
38 37. --
39 38. --
40 39. --
6 720 862 438 (2016/04)
Display content
Outdoor unit address
Individual Outdoor unit capacity
Modular outdoor unit qty.
Operation mode
Total capacity of outdoor units
Cooling capacity
Heating capacity
T4 ambient temp. revision of cooling capacity
T4 ambient temp. revision of heating capacity
The outdoor unit actual operating capacity
Speed of fan A
Speed of fan B
T2 average temp.
T2B average temp.
T3 pipe temp. (Left pipe temp.)
T5 pipe temp. (Right pipe temp.)
T4 ambient temp.
Discharge temp. of inverter compressor A
Discharge temp. of inverter compressor B
Modual temp.
Discharge pressure corresponding to the saturation temperature
The minimum overheating temp. of discharge
Current of inverter compressor A
Current of inverter compressor B
State of the evaporator or condenser
Opening angle of EXV A
Opening angle of EXV B
High pressure
Qty. of indoor units
Qty. of cooling indoor units
Qty. of heating indoor units
Reserve
Night noise control mode
Static pressure mode
DC voltage A
DC voltage B
Reserve
Reserve
Remove fault number of times
MAIN BOARD
(OUTDOOR UNIT)
Query button
Forced cooling button
CHECK COOL
Note
0,1,2,3
8,10,12,14,16
Available for main unit
0,2,3,4,5,6
Capacity requirement
(Auxiliary unit only) display capacity for main mode
(Auxiliary unit only) display capacity for main mode
Capacity requirement
0, 1,······,14,15
0, 1,······,14,15
Actual value
Actual value
Actual value
Actual value
Actual value
Actual value
Actual value
Actual value
Actual value + 30
Actual value
Actual value
Actual value
0,1,2,3
Actual value ÷ 8
Actual value ÷ 8
Actual value × 10
That can communicate with indoor units
Actual value
Actual value
0,1,2,3
0,1,2,3
Actual value÷10
Actual value÷10
Display code 8.8.8
Check end
RDCI Series – All DC Inverter Outdoor Units
Fig. 6-1