Table of Contents
Advertisement
1.
AP300 GENERAL
1.1.
GENERAL
This installation Manual is valid for installing a DECT transceiver (AP300) to a wall in
horizontal or vertical position. The AP300 is designed for indoor use. When installing an
AP300 outdoors, please use the dedicated Outdoor Cabinet:
Note that there are two types of DECT Tranceivers::
AP300 (with internal antennas).
AP300E with directional antenna.
Note: The AP300E must always be installed/used in the outdoor cabinet! For more
information consult the manual for the Outdoor Cabinet for AP300.
1.2.
COUNTRY SELECTION
The AP300 is equipped for EMEA, Latin America and North America. However, the DAP
Controller determines the frequency used and the power level. The DAP Controller is the
software that runs on a PC to control the AP300.
There are three types of DAP Controllers available for the AP300:
− DAP Controller – International.
This version is used in EMEA countries and countries that use the European
frequencies and power levels.
− DAP Controller - North America
This version is used in North America.
− DAP Controller - Selective Countries.
This version is used in countries with other frequency ranges than EMEA or North
America
Note: In North America, only the "DAP Controller - North America" will be delivered, so no
other frequencies than the North America frequencies and power levels are possible
in North America.
Note: In Europe, only the "DAP Controller - International" will be delivered, so no other
frequencies than the European frequencies and power levels are possible in
Europe.
March 2010
All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner
AP300 Customer Engineer Manual
3
Hide quick links:
Advertisement
Chapters
Table of Contents
