NEC AP300 Installation Manual page 36

9. Drill the holes in the wall using an appropriate drill that is applicable for the wall.
10. Mount the cabinet to the wall. Use appropriate screws and plugs.
11. Push the special nuts that came with the cabinet into the corner holes of the cabinet.
Figure 8. Pushing the special nuts in place in the corners of the cabinet.
12. Lead the cable via the swivel into the cabinet. Note: the cable length in the cabinet
must be 20 cm (this includes the RJ45 connector which you have to mount to the
cable later on.).
Note: At the outside of the box, the cable must be led directly from the cabinet into
the building to avoid exposing the cable to lightning.
13. Tighten the cable inlet on the swivel and make sure that the cable inlet is waterproof.
March 2010
All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner
Figure 7. Mounting the cabinet to the wall.
Outdoor Cabinet Installation Manual 7