Installing Ap300 With Internal Antennas - NEC AP300 Installation Manual

2.

INSTALLING AP300 WITH INTERNAL ANTENNAS

Procedure for installing the Outdoor Box with AP300 with internal antennas:
1. Open the Cabinet. To open the cabinet, use a screw driver that fits into the four
plastic screws at the front side of the cabinet. Unfasten the screws.
2. Remove the cover from the cabinet. The contents of the cabinet is shown in Figure 1.
Contents of the box.
3. Remove the foam contents from the cabinet.
4. At the right hand side of the cabinet, you will have to drill a hole for the cable inlet.
Mark the hole as follows:
16 mm
4
All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner
Figure 1. Contents of the box.
Right side of cabinet
117 mm
Figure 2. Position of the hole in the cabinet.
Outdoor Cabinet Isolated - Installation Manual March 2010