Setting The Clock - Sony RXD-700 Operating Instructions Manual

Getting Started
The arrow ç indicates signal flow.
CD Receiver
T A P E
REC OUT LINE IN
L
R
The audio signal of the currently selected source (CD
or tuner) is output through the TAPE OUT jacks.
Connecting the mains lead
Connect the mains lead to a wall outlet.
Note
Separate the mains lead, audio cords and speaker cords.
Noise or sound deterioration may occur when audio cords are
in contact with the mains lead, or when the mains lead or
speaker cords are placed near a loop aerial or aerial wire.
Before using the CD Receiver for the first
time
You need to reset the CD Receiver.
While the power is off, press TAPE while holding
down PRESET –.
"All Clear" appears in the display.
Note
When you reset the CD Receiver, all the preset radio
stations are erased.
EN
6
Tape deck
OUTPUT INPUT
LINE LINE
L
L
Ç
R
R
ç
PRESET – TAPE

Setting the Clock

You must set the time before using the timer functions.
CLOCK SET TIMER +/–
1
Press CLOCK SET.
The hour indication flashes.
- - : - -
2
Press TIMER +/– to set the hour.
The clock uses the 24-hour system.
7 : - -
3
Press ENTER.
The minute indication flashes.
7 : - -
4
Press TIMER +/– to set the minute.
7 : O O
5
Press ENTER.
The clock starts.
To adjust the clock after you have set it
Press CLOCK SET and hold down until the hour indication of
the clock starts flashing (about one second), then adjust the
clock following the above procedure.
ENTER