Additional Information; Notes On Cds; Troubleshooting - Sony RXD-700 Operating Instructions Manual

Additional Information

Notes on CDs

On handling CDs
• To keep the disc clean, handle the disc by its edge. Do not
touch the surface.
• Do not stick paper or tape on the CD.
• Do not expose the CD to direct sunlight or heat sources
such as hot air ducts, nor leave it in a car parked in direct
sunlight as there can be considerable rise in temperature
inside the car.
• Do not use any commercially available stabiliser and/or
disc protector. If you do, the CD and this unit may be
damaged.
• After playing, store the CD in its case.
On cleaning
• Before playing, clean the disc with a cleaning cloth. Wipe
the CD from the centre to out.
• Do not use solvents such as benzine, thinner,
commercially available cleaners or anti-static spray
intended for vinyl LPs.

Troubleshooting

If you experience any of the following difficulties while
using the CD Receiver, use this troubleshooting guide
to help you remedy the problem. Should any problem
persist, consult your nearest Sony dealer.
There's no sound.
Not this way
No audio from one channel or unbalanced speaker output.
Weak bass or treble.
Distorted sound.
Lack of bass or ambiguity in instrument positions.
Hum or noise.
The remote does not function.
Additional Information Additional Information Additional Information
/Connect the audio connecting cord firmly.
/Connect the CD Receiver and other audio
components correctly.
/Connect the aerials.
/Press the function button of the appropriate
programme source.
/You have not pressed the SPEAKER A or B
button.
/Turn BAL to adjust the balance.
/Check the speaker and input connections of the
silent channel.
/Change speaker positions or room conditions to
eliminate obstructions in sound path.
/Improperly selected input signal
/Insufficient input capacity of speakers. Lower
the volume.
/Speaker cord and terminal polarity are
reversed. Reconnect the cords with correct
polarity.
Connect the audio connecting cords firmly.
/
The CD Receiver is picking up interference
/
from a TV set. Move the CD Receiver away
from the TV set or turn the TV set off.
/Remove the obstacles in the path of the remote
and the CD Receiver.
/Point the remote at the remote sensor g on the
CD Receiver.
/The remote is too far from the CD Receiver.
Move closer to the CD Receiver.
/Replace both batteries in the remote with new
ones if they are weak.
.
EN
17